Time saver when making molds. No longer have to wait for resin to cure after each layer, this can lay up 4 or 5 layers all in one go. Doesn’t shrink, and I add a bit extra aluminium powder for extra heat resistance!
After using general purpose and value range gelcoat for molds, I tried this, and it is way way better. Polishes really well and even copes with 90 degree oven cure Prepreg.
A perfect service. The cleaner was delivered quickly with no fuss. I will definitely use FSL Plymouth again.
Absolutely fantastic company used for first time and made these tealight holders ... Perfect
Brilliant service products and quality.
The gelcoat filler is an excellent colour mix, my only slight criticism would be that I would have preferred it to be slightly thicker ( less liquidy), but it’s still very useable
Excellent product, very easy to use and great results.
Great value, delivered quickly and efficiently. Recommended for excellent service
As a DIY pensioner I required some Acetone for cleaning brushes from contaminants such a fiberglass gel or specialised paints ; having spent many years as a University Technician I was familiar with the chemical. Local chemists only supplied 50 ml, far too little for my purpose. I found FSL on the Web who supplied 1000ml overnight in a well packaged delivery. .Product is fine, and I am pleased with the service from FSL. Pity the Postage costs as much as the product, obviously not their fault.
Best ever stain , dirty marks , water line cleaner . Will never use anything else .
My boat was badly rust-stained inside. The cleaner was very effective in removing the marks
Easy to use foam. Fast acting. I tested small amounts first and achieved around 16x expansion by warming the foam to 20 degrees C, aerating part A as suggested in the directions, and ensuring that the room and surfaces were around 18-20 degrees. Could not get the "up to 25x" described on the tine but this was my first time using 2-part foam so perhaps it would improve with practice.
Not used for sealing a tank but painted on to seal porous alloy inside motorcycle carb bodies. Does the job nicely.
Great for accurate measure of small amounts
Easy to use and better value than ready to use products
Easy to navigate site, quick delivery, goods well packaged, great service. Thank you
This is perfect tooling gelcoat, polishes really well, and is great value for money.
This is cheap as chips and is perfect for making cheap molds, does need mixing well, as solids settle in the jugs,
These oxalic acid crystals are easy to mix with water and when I tried it on some ingrained brown hull stain I applied it and left it for 10 minutes or so and my hull just cleaned itself. All that was needed then was a rinse off, dry and then it was ready for polishing.. I was impressed.
